Limpiador de suelos 3 en 1 Karcher FCV 3 1.056-122.0 — en seco y en húmedo, 160 W, blanco

Karcher FCV 3 is a 2‑in‑1 floor cleaner combining vacuuming, washing and drying in one cordless device. The Xtra!Clean system cleans hard floors, rugs and small liquid spills using selectable cleaning modes and an integrated self‑cleaning function. The device features Hygienic!Spin brush technology and a lithium‑ion battery that provides up to 30 minutes of runtime, enabling continuous cleaning of areas up to approximately 130 m² without a prior vacuuming step.

Advantages

The Xtra!Clean “three‑in‑one” concept vacuums, washes and dries floors in a single pass, reducing total cleaning time. Hygienic!Spin technology delivers high brush speeds to remove dirt efficiently and has been shown in tests to eliminate up to 99% of bacteria. A two‑tank system keeps clean water separate from collected dirty water for hygienic operation, while the Duo!Pure multi‑stage filter protects the motor and provides effective air filtration. The removable lithium‑ion battery supports fast replacement and up to 30 minutes of cordless operation, and the integrated System!Clean function and LED display simplify maintenance and show remaining run time and mode information.

Suitable for

• Daily cleaning of hard floors (tile, laminate, sealed wood)
• Quick removal of spills and damp dirt
• Light cleaning of area rugs and floor coverings in dry mode
• Homes with pets where hair and tracked‑in dirt are common

Key specifications

• Cleaning modes: standard (water feed), dry cleaning, Advanced!Power
• Clean water tank capacity: 800 ml
• Dirty water tank capacity: 425 ml
• Maximum input power: 160 W
• Brush width: 240 mm
• Brush speed: up to 500 rpm (cleaning) / up to 550 rpm (self‑clean)
• Battery: lithium‑ion, 21.6 V
• Battery run time: up to 30 minutes
• Charging time: approx. 180 minutes
• Typical floor drying time: about 2 minutes
• Area per charge (approx.): 130 m²
• Weight without accessories: 3.8 kg
• Colour: white

How to use

Choose the appropriate cleaning mode for the task: standard mode for regular wet cleaning, dry mode for rugs and carpets, or Advanced!Power for stubborn, dried‑on dirt. Fill the clean water tank with water and detergent according to the manufacturer’s instructions, snap the tanks into place and switch the device on. Guide the cleaner slowly over the surface to allow the brushes and suction to remove dirt and moisture; the integrated drying function reduces surface wetness. After cleaning, use the System!Clean self‑cleaning cycle and empty the dirty water tank; follow indicated prompts on the LED display.

Recommendations

For best results on hard sealed floors, use the standard cleaning mode with the supplied universal cleaning solution. Use dry mode for carpets and floor coverings and Advanced!Power only for heavily soiled spots. Empty and rinse the dirty water tank after each use and run the self‑cleaning cycle regularly to maintain hygiene and performance.