Lámpara de xenón HID IWH D2S 35W 85V para faros de coche

Xenon HID lamp IWH D2S 35W 85V bulb for automotive headlights is a short-arc high-intensity discharge lamp designed for vehicles requiring a D2S base. With a rated power of 35 W and operating voltage around 85 V, this xenon lamp produces bright white light suitable for headlight systems that use HID technology. It is intended for use in factory or replacement xenon ballasts and provides improved roadway visibility compared with standard halogen bulbs.

Advantages

The IWH D2S 35W 85V lamp offers a stable light output with a color tone close to daylight, consistent lumen performance during operation, and compatibility with automotive HID ballast units designed for D2S fittings. Its short-arc design delivers concentrated beam control through projector housings, supporting clear cut-off lines and minimizing stray glare when installed correctly. The lamp's power and voltage ratings match common xenon headlight systems, making it suitable for direct replacement in compatible vehicles.

Suitable for

Key specifications

How to use

Install the IWH D2S 35W 85V lamp only into headlight units designed for D2S bulbs and compatible xenon ballasts. Before installation, disconnect the vehicle battery and allow the old bulb and ballast to cool. Handle the lamp by its ceramic base or housing and avoid touching the glass arc tube with bare fingers. Secure the lamp into the bulb holder and reconnect wiring to the ballast following the vehicle manufacturer's guidance. After installation, check beam alignment and adjust the headlight aim if necessary to ensure correct cut-off and to avoid dazzling other road users.

Recommendations

For safe and reliable performance, use the IWH D2S lamp with a matching 35W xenon ballast and ensure the headlight housing and projector optics are intact. Replace bulbs in pairs to maintain uniform color and intensity across both headlights. If there are ignition errors or flickering after installation, inspect ballast compatibility and electrical connections or consult a qualified technician.