Lámpara universal de tira LED Eurolite 50506090 9000 mm multi 324 bombillas

The EUROLITE Universal strip light 50506090 is a 9,000 mm LED lighting solution with 324 bulbs configured for multi‑color output. Designed for both indoor and outdoor installations, the strip delivers dynamic colour effects while maintaining a slim profile — 13 mm width and 13 mm thickness — and connects to a 230 V AC supply via a 1.5 m cable. With a rated consumption of 140 W, the unit is suitable for extended runs where continuous, even LED illumination is required.

Advantages

The strip offers multi‑color LED control across a long 9 m length, providing uniform light distribution from densely arranged LEDs. Its low-profile construction enables discreet mounting in coves, behind trims, or on façades. Rated for AC 230 V operation and a 1.5 m connection cable, the product is ready for direct mains installation where compatible controllers and power management are available. The relatively high bulb count ensures consistent colour mixing and reduced banding along the run.

Suitable for

Key specifications

How to use

Mount the LED strip on a clean, dry surface using suitable clips, channels or adhesive designed for LED strips. Ensure the mounting route provides adequate support for the 9 m length and prevents sharp bends. Connect the strip to a compatible controller and to a 230 V AC supply using the supplied 1.5 m cable or approved extension, following electrical safety standards. For outdoor installations, house the strip within weather‑protected channels or enclosures and seal end points to prevent moisture ingress. Test the full length after installation to confirm even colour output and proper operation of all LEDs.

Recommendations

Use LED‑rated drivers and controllers that match the strip's voltage and power requirements; allow for a safety margin when selecting power supplies. For long runs, consider power injection points or parallel feeds to reduce voltage drop and colour shift. Maintain recommended ambient temperature ranges and prevent exposure to direct mechanical stress or prolonged water immersion. For exterior use, install within IP‑rated profiles and follow local electrical codes.