LANCOM Systems OW-602 — Cat6a S/FTP, RJ-45 a RJ-45, 15 m, negro

The Lancom Systems OW-602 — Cat6a S/FTP, RJ-45 to RJ-45, 15 m, black is a 15 metre Ethernet patch cable designed for high-performance LAN installations. Compliant with the Cat6a standard and featuring S/FTP (S‑STP) shielding, this cable reduces crosstalk and electromagnetic interference to support gigabit and 10GBASE‑T connections. Fitted with RJ‑45 connectors on both ends, it is suitable for connecting switches, routers, servers, workstations and PoE-capable devices. The cable jacket is weather-resistant and UV-stable for outdoor use, enabling installation of outdoor access points such as the LANCOM OW-602 while maintaining signal and power delivery.

Advantages

The Cat6a construction and S/FTP shielding ensure consistent high-speed data transmission with reduced interference, making the cable appropriate for environments where signal integrity matters. RJ-45 terminations on both ends provide broad compatibility with common network equipment. The cable supports Power over Ethernet delivery to PoE-capable devices, allowing devices to receive power and data over a single cable. A weather-resistant, UV-stable outer jacket and a wide operating temperature range make the cable suitable for outdoor deployments where exposure to sun and varying temperatures is expected.

Suitable for

• Connecting PoE-capable outdoor access points such as LANCOM OW-602 to switches or PoE injectors
• Gigabit and 10GBASE-T links between network equipment (switches, routers, servers)
• Longer patch runs where enhanced shielding is needed to reduce EMI and crosstalk

Key specifications

• Cable category: Cat6a
• Shielding: S/FTP (overall braid with individually shielded pairs)
• Connector type: RJ-45 to RJ-45 (straight)
• Length: 15 m
• Colour: Black
• Supports Power over Ethernet (PoE)
• Designed for outdoor use: UV-resistant jacket and weather-resistant construction

How to use

Plug one RJ-45 connector into a PoE-capable switch or PoE injector and the other into the network port of the outdoor access point or network device. Ensure connectors are fully seated and that cable routing avoids sharp bends and sources of mechanical strain. For outdoor deployments, route the cable using appropriate clips or conduits and seal any outdoor terminations or couplers against moisture. Verify link speed and PoE power delivery after installation using the network equipment's management interface or indicators.

Recommendations

For reliable outdoor operation, use compatible waterproof connectors or gland fittings at building entry points and keep cable runs clear of high-voltage lines and large electrical equipment to minimise EMI. Regularly inspect the jacket for damage after extreme weather; replace the cable if the sheath is compromised. When longer runs or additional protection are required, consider routing the cable through conduit and following local installation standards for outdoor network cabling.