LED Neon Flex 230V EUROLITE fino blanco frío 100 cm - tira de luz LED flexible

The EUROLITE LED neon flex 230V Slim in cold white is a 100 cm flexible LED strip designed for continuous, linear illumination. Its slim profile delivers diffused, even light that simulates traditional neon while operating directly from 230V mains. The product is intended for indoor and protected outdoor use where a neat, low-profile light line is required for signage, accent illumination, coving, or architectural detail highlighting.

Advantages

This slim LED neon flex provides uniform light distribution with low flicker and consistent cold white color output. As a mains-powered solution it eliminates the need for external low-voltage drivers in many installations, simplifying wiring and reducing component count. The flexible construction allows gentle curves and continuous runs, while the durable housing offers protection against dust and accidental contact in appropriately rated environments. Low power consumption and long operating life reduce maintenance efforts compared with incandescent or gas-based neon alternatives.

Suitable for

Key specifications

How to use

Mount the LED neon flex on a clean, dry surface using the recommended mounting clips or aluminum channels that match the slim profile. Ensure the power is switched off at the supply before making electrical connections; connect directly to a 230 V mains circuit following local electrical codes and regulations. If cutting is permitted by the manufacturer, cut only at marked intervals and seal the cut end properly to maintain the housing protection. Route cables to avoid sharp bends and secure the strip at regular intervals to prevent sagging and maintain an even light line.

Recommendations

For best performance, install the product in environments within the manufacturer’s specified temperature and moisture limits and protect exposed end terminations from direct weather when used outdoors. Use compatible mounting accessories and, where long continuous runs are required, verify voltage drop impact and connection points. Have electrical connections performed by a qualified electrician to ensure compliance with local safety standards.