Llave combinada Gedore 6089710

The Gedore 6089710 combination wrench is manufactured from Gedore vanadium steel (31CrV3) with a chrome-plated finish and conforms to DIN 3113 Form A, ISO 3318 and ISO 7738 standards. The ring end is offset 15° from the shaft and arranged in a girder pattern. Sizes 3 to 5.5 are supplied with a hexagon ring, while sizes from 6 upward use a UD profile. The product has a depth of 48 mm, a height of 23 mm and a mass of 24 g.

Advantages

The chrome-plated 31CrV3 vanadium steel construction provides strength and corrosion resistance while keeping the tool lightweight. Standardised dimensions (where applicable) ensure compatibility with corresponding nuts and bolts, and the 15° offset ring facilitates access in confined spaces. The different ring profiles by size (hexagon for 3–5.5, UD from 6) match typical fastening needs.

Suitable for

Key specifications

How to use

Select the correct wrench size for the nut or bolt, place the ring end over the fastener, and apply steady force to turn. Use the offset ring to reach fasteners at an angle or in confined areas. For continued access, reposition the wrench on the fastener as needed and work with controlled torque consistent with the fastener specification.

Recommendations

Inspect the wrench periodically for wear or damage, keep the chrome finish clean and lightly oiled to reduce corrosion, and avoid using the wrench as a hammer or lever beyond its intended capacity. Follow applicable torque specifications for bolts to prevent rounding or damage.