Llave de boca Gedore 6056970 peso 59 g profundidad de embalaje 64 mm

Open end wrench manufactured by Gedore according to DIN 3118 with a ring offset of 15° from the shaft. The tool combines an open end and a ring profile: the ring is set at a 15° angle relative to the shaft, and the open hexagon jaw has a 30° offset. Available sizes include 8x10 mm up to 12x14 mm with a hexagon jaw. Made from vanadium steel (31CrV3) and chrome-plated for surface protection. One variant noted is not standardised.

Advantages

The Gedore open end wrench offers a combination of ring and open jaw geometry that enables access in confined spaces and allows multiple engagement angles. Constructed from vanadium steel (31CrV3) with chrome plating, the wrench provides good durability and corrosion resistance for workshop and field use. Precise offsets (15° ring, 30° open jaw) aid in repeatable positioning on fasteners.

Suitable for

Key specifications

How to use

Select the correct wrench size for the fastener and place the open jaw or ring over the nut or bolt head. Use the offset angles to approach fasteners from above or the side when clearance is limited. Apply steady torque, repositioning the tool as needed to achieve the desired rotation; avoid using excessive force or hammering the tool to prevent damage to the wrench or fastener.

Recommendations

Store the chrome-plated vanadium steel wrench in a dry toolbox, clean and lightly oil after use to maintain corrosion resistance. Use the correct size and the ring end for final tightening where higher contact should be preferred to reduce rounding of fastener corners.