LOGON Cable de red Cat6a U/UTP 15 m Blanco marfil, RJ-45–RJ-45

LOGON Cat6a networking cable, 15 m length, U/UTP construction in ivory colour. This patch cable has RJ-45 connectors on both ends and is designed to deliver Cat6a performance for 10 Gigabit Ethernet over copper. The cable jacket is Low Smoke, Halogen Free (LSOH), making it suitable for indoor installations in homes and offices where reduced smoke and halogen emissions are preferred. Its unshielded overall design provides flexible handling and reliable signal transmission for patching and local area network wiring.

Advantages

The cable supports Cat6a specifications to maintain bandwidth and signal integrity up to 10 Gbps at suitable distances, making it appropriate for high-speed network segments. U/UTP construction simplifies installation and routing in standard network environments, while the LSOH jacket reduces hazardous emissions in the event of fire. Fitted RJ-45 connectors enable plug-and-play connectivity with switches, routers, patch panels and network devices without additional adapters.

Suitable for

• Patching between switches, patch panels and wall outlets in home or office LANs
• Connecting desktop PCs, network printers, NAS devices and IP cameras
• Short to medium length horizontal runs within racks, cabinets and underfloor channels
• Environments requiring LSOH cabling for safety compliance

Key specifications

• Category: Cat6a performance for 10 Gigabit Ethernet over copper
• Construction: U/UTP (unshielded overall, no individual pair shielding)
• Length: 15 m
• Connectors: RJ-45 male to RJ-45 male
• Jacket material: Low Smoke, Halogen Free (LSOH)
• Colour: Ivory
• Installation type: Patch cable, plug-and-play

How to use

Insert each RJ-45 plug into the corresponding Ethernet port on network devices such as a switch, router, patch panel or computer. Ensure connectors are fully seated until the latch clicks to establish a secure connection. For optimal performance, avoid sharp bends or kinks in the cable and keep it separated from strong electromagnetic sources such as unshielded power conductors. Route the cable through cable management trays, conduits or tie-down points to prevent strain on the connectors.

Recommendations

For 10 Gigabit Ethernet, keep horizontal run lengths within recommended distances for Cat6a copper cabling and use tested infrastructure components. When installing in shared conduits or near potential sources of interference, consider cable routing and separation practices to maintain signal quality. Regularly inspect connectors for secure seating and replace cables that show visible damage to the jacket or connectors.