MEMORIA DIMM 32GB DDR5-5200 K2/5200J4040A16GX2-RS5K G.SKILL

G.SKILL Ripjaws S5 dual-channel memory kit, 32 GB (2x16 GB) DDR5 at 5200 MHz, offers a balanced combination of capacity, frequency and low operating voltage for modern desktop systems and workstations. Each 288-pin DIMM module is designed for DDR5-capable motherboards and runs at 1.1 V with CAS latency 40. The modules feature a black heatsink for a discreet appearance and reliable heat dissipation during sustained loads. This kit is intended to increase system responsiveness, improve multitasking and raise overall data throughput in supported systems.

Advantages

The Ripjaws S5 kit provides 32 GB of DDR5 memory in a matched dual-channel configuration, enabling higher aggregate bandwidth compared with single-module setups. Operating at 5200 MHz and CL40 latency, these modules deliver a combination of speed and predictable timing suited to general productivity, content creation and gaming. Low 1.1 V operating voltage reduces power consumption and thermal output relative to higher-voltage modules. The black heatsink adds mechanical protection and helps maintain stable temperatures under load.

Suitable for

• High-performance desktops and gaming PCs that support DDR5 memory
• Workstations used for photo/video editing and multitasking
• Users upgrading from DDR4 to DDR5 seeking 32 GB capacity in dual-channel
• Systems requiring a low-voltage memory solution for reduced power draw

Key specifications

• Total capacity: 32 GB (2 x 16 GB)
• Memory type: DDR5
• Speed: 5200 MHz
• CAS latency: CL40
• Operating voltage: 1.1 V
• Form factor: 288-pin DIMM
• Module color/finish: black heatsink
• Unbuffered (unregistered) memory

How to use

Power off the PC and disconnect it from mains before installing memory modules. Open the system case and locate the DDR5-compatible DIMM slots on the motherboard. Consult the motherboard manual for the recommended slot population for dual-channel operation, then align each 288-pin module with the slot notch and press evenly until the retention clips click into place. Reconnect power and enter the system BIOS/UEFI to confirm that the modules are detected and running at the default JEDEC or any supported XMP/DOCP profile as required. If necessary, enable the appropriate memory profile in BIOS to reach rated 5200 MHz speed and verify stability with standard system testing tools.

Recommendations

Install the modules in the motherboard slots specified for dual-channel operation to achieve optimal bandwidth. When enabling higher-speed profiles, ensure your motherboard and CPU officially support the target frequency. Allow for adequate case airflow around the memory area to maintain thermal stability during sustained workloads. For mixed-memory systems, use modules with matching specifications to avoid stability issues.