Memoria RAM Silicon Power XPOWER Zenith RGB DDR4 16GB (1x16GB) 3200MHz CL16 UDIMM 1Gx8 DR disipador

The Silicon Power XPOWER Zenith RGB DDR4 16 GB 3200 MHz memory module delivers 16 GB of DDR4 RAM at 3200 MHz in a 288-pin DIMM form factor with 1.35 V operation and CAS latency 16. Built for gaming PCs and performance builds, the module combines high-speed memory with an integrated RGB light band and an aluminum heat spreader to balance performance and thermal management.

Advantages

The module offers stable high-frequency operation (3200 MHz) with low voltage (1.35 V) and is factory-tested for compatibility and reliability. A textured iron-grey aluminum heat spreader enhances heat dissipation to reduce thermal throttling during extended use. The integrated RGB lighting is compatible with major motherboard lighting ecosystems, allowing synchronized illumination across supported systems.

Suitable for

• Gaming PCs and enthusiast builds
• PC modders who want RGB lighting
• High-performance desktop workstations
• Systems requiring 288-pin DIMM DDR4 memory

Key specifications

• Capacity: 16 GB
• Type: DDR4
• Speed: 3200 MHz
• Form factor: 288-pin DIMM
• Voltage: 1.35 V
• CAS Latency: 16
• Manufacturer model: SP016GXLZU320BSD
• EAN: 4713436143109

How to use

Power off the PC and unplug it from the mains before installing. Open the case and locate the appropriate DDR4 DIMM slots on the motherboard. Align the notch on the module with the slot key, press firmly until the retention clips lock in place. After installation, power on the system and enable or configure RGB lighting via the motherboard's supported software (ASUS Aura Sync, GIGABYTE RGB Fusion, MSI Mystic Light Sync, or ASRock Polychrome Sync) if synchronized lighting is required.

Recommendations

For best results, install matching DDR4 modules in paired slots according to your motherboard manual to enable dual-channel operation. Ensure BIOS/UEFI settings or XMP profiles are configured if you require the module to run at its rated 3200 MHz speed.