Microconnect B-FTP6015Y Cable de red amarillo 1,5 m Cat6 F/UTP (FTP)

The MicroConnect B-FTP6015Y is a 1.5 m RJ-45 Cat6 networking cable with F/UTP shielding and a yellow jacket. It supports high-speed data transfer up to 10000 Mbit/s and is suitable for connecting switches, modems, routers or patch panels in home and small office networks. The cable is manufactured to Cat6 standard and tested up to 250 MHz, and is backwards compatible with Cat5e and Cat5.

Advantages

This shielded Cat6 cable provides reduced electromagnetic interference (EMI) and improved protection against crosstalk, helping to maintain data integrity and stable transmission rates. RJ-45 connectors on both ends and latch protection reduce the risk of connector damage during installation in tight spaces. The yellow jacket makes the cable easy to identify within an installation.

Suitable for

• Connecting switches, routers or modems to patch panels or wall outlets
• Home networks and small office network installations
• Entertainment setups such as smart TVs, streaming devices and game consoles
• Environments requiring reduced EMI and improved signal reliability

Key specifications

• Model: MicroConnect B-FTP6015Y
• Length: 1.5 m
• Category: Cat6 (tested up to 250 MHz)
• Maximum data rate: up to 10000 Mbit/s
• Connectors: RJ-45 to RJ-45
• Shielding: F/UTP (foil with overall braid shielding)
• Color: Yellow
• Weight: 0.036 kg
• Backward compatibility: Cat5e, Cat5

How to use

Plug one RJ-45 connector into your network device (switch, router or modem) and the other into the destination port such as a patch panel, keystone jack or wall outlet. Ensure connectors are fully inserted until the latch clicks to secure the connection. Route the cable avoiding sharp bends and sources of strong electromagnetic noise when possible. For permanent installations, leave some slack to allow for future adjustments.

Recommendations

For best performance, use the MicroConnect B-FTP6015Y in shielded or grounded installations where EMI is a concern, and avoid running the cable parallel to high-voltage power lines. Verify connectors are undamaged before use and replace the cable if the shielding or jacket is compromised.