Microconnect B-FTP602S Cable de red negro 2 m Cat6 F/UTP (FTP)

The Microconnect B-FTP602S is a 2 m Cat6 networking cable with F/UTP shielding and RJ-45 connectors on both ends. It supports Cat6 performance up to 250 MHz and data rates up to 10000 Mbit/s, making it suitable for reliable wired connections between switches, modems, routers and network infrastructure components such as patch panels, keystone jacks or wall outlets. The cable is finished in black and includes a latch protection design to reduce the risk of connector damage during installation in tight spaces.

Advantages

Shielded construction (F/UTP) reduces electromagnetic interference (EMI) and minimizes crosstalk, which helps maintain data integrity and stable transmission speeds. The cable is backward compatible with Cat5e and Cat5 systems and is manufactured to meet Cat6 testing up to 250 MHz. Latch protection on the RJ-45 plugs prevents accidental damage to the connector tab during installation.

Suitable for

• Wired connections between switches, routers and modems
• Patch panel and keystone jack terminations
• Small office and home networks
• Entertainment systems and wired streaming setups

Key specifications

• Standard: Cat6 (tested up to 250 MHz)
• Shielding: F/UTP (foil shielded twisted pairs with overall unshielded braid)
• Length: 2 m
• Connectors: RJ-45 to RJ-45 with latch protection
• Color: Black
• Typical maximum data rate: up to 10000 Mbit/s (as specified)

How to use

Connect one RJ-45 plug to your network device (switch, router or modem) and the other plug to the target device or infrastructure point such as a patch panel, keystone jack or wall outlet. Ensure connectors are fully inserted until the latch clicks to secure the connection. Route the cable without sharp bends and avoid running it in parallel and close proximity to high-power electrical cables to reduce possible interference.

Recommendations

For best performance, use the Microconnect B-FTP602S for short to medium length runs within office and home environments, keep the cable untwisted at connector terminations to a minimum, and avoid excessive bending. When installing in spaces with potential strong EMI, prefer the shielded F/UTP cable to unshielded alternatives.