Microconnect B-UTP510O Cable de red naranja 10 m Cat5e U/UTP (UTP)

The Microconnect B-UTP510O is a 10 m Cat5e networking cable with RJ-45 connectors on both ends and U/UTP (unshielded twisted pair) construction. It supports transmission up to the Cat5e standard (tested to 100 MHz) and is suitable for connecting switches, modems, routers, patch panels, keystone jacks or wall outlets in home and small office networks. The cable is orange for easy identification and includes latch protection to reduce risk of connector damage during installation in tight spaces.

Advantages

This Cat5e cable provides a reliable, standards-compliant connection for Ethernet networks, is backwards compatible with Cat5, and is tested to 100 MHz. The RJ-45 connectors on both ends ensure broad compatibility with networking equipment. Latch protection helps prevent clip breakage when routing the cable through crowded or confined installations, and the bright orange color simplifies cable management and identification.

Suitable for

• Connecting switches, routers and modems
• Patch panel to device or keystone jack connections
• Home and small office Ethernet networks
• Temporary or permanent cabling where easy identification is required

Key specifications

• Length: 10 m
• Standard: Cat5e (tested to 100 MHz)
• Maximum supported data rate: up to 1000 Mbit/s (Gigabit Ethernet over Cat5e conditions)
• Connectors: RJ-45 — both ends
• Construction: U/UTP (unshielded twisted pair)
• Color: Orange
• Weight: 0.14 kg
• MPN: B-UTP510O
• EAN: 5711045730122

How to use

Connect one RJ-45 end of the Microconnect B-UTP510O cable to the Ethernet port of your device (switch, router, modem or network interface) and the other end to the target port, patch panel or wall jack. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and avoid running parallel to power lines to reduce interference. For installations in tight spaces, press the latch protection gently while inserting to prevent clip damage.

Recommendations

For reliable Gigabit performance, keep cable runs within recommended lengths for structured cabling (up to 100 m for permanent links) and use Cat5e-compliant hardware. Inspect connectors for debris before inserting and avoid excessive bending or crushing of the cable during installation.