Microconnect HDMVGA1 Cable adaptador de vídeo 0,15 m HDMI Type-A (estándar) VGA (D-Sub) blanco

The Microconnect HDMVGA1 is a compact 0.15 m video cable adapter that converts an HDMI Type A (Standard) output to a VGA (D-Sub) input. It enables display of video content from devices with HDMI output to monitors, projectors or other displays that accept VGA input. The adapter is RoHS certified, lightweight (30 g) and comes in a white finish, making it suitable for portable setups and simple installations.

Advantages

The adapter provides a straightforward HDMI to VGA signal conversion without requiring a separate power source for typical use cases. Its short 0.15 m length and small diameter (4.8 mm) make it unobtrusive and easy to route behind equipment. The lightweight design and compact packaging support convenient transport and storage.

Suitable for

• Connecting HDMI-equipped laptops, media players or set-top boxes to VGA monitors
• Presentations with projectors that only have VGA input
• Temporary workstation setups where only VGA displays are available

Key specifications

• Connector 1: HDMI Type A (Standard)
• Connector 2: VGA (D-Sub)
• Length: 0.15 m
• Diameter: 4.8 mm
• Weight: 0.03 kg
• Colour: White
• RoHS certified

How to use

Connect the HDMI Type A plug to the HDMI output of your source device and insert the VGA (D-Sub) connector into the VGA input of the display. Secure both ends if required by the display hardware. Switch the display to the correct input and configure the source device’s display settings (resolution and output mode) as needed to match the VGA monitor or projector.

Recommendations

For best results, set the source device to a resolution and refresh rate supported by the target VGA display. If you experience no signal, verify cable seating and display input selection; some HDMI sources may require active conversion for HDCP-protected or high-resolution content.