Microconnect MC-SFTP6A0025S Cable de red Negro 0,25 m Cat6a S/FTP (S-STP)

The MicroConnect MC-SFTP6A0025S is a Cat6a S/FTP patch cable with a length of 0.25 m designed for high-speed network connections. It supports data rates up to 10 000 Mbit/s and bandwidths up to 500 MHz, and uses RJ-45 connectors with gold-plated contacts for reliable signal transfer. The cable is black, lightweight and intended for use in installations where minimal interference and stable 10G performance are required.

Advantages

This Cat6a cable provides S/FTP shielding to reduce electromagnetic interference and maintain stable transmission at high speeds. Gold-plated RJ45 contacts improve conductivity and corrosion resistance. The cable boots include meter markings for quick length identification, and the connector latches have protection to reduce the risk of clip breakage. The short 0.25 m length is convenient for tidy connections in patch panels, racks or close-proximity devices.

Suitable for

• Short patch connections between network devices (switch to router, switch to server)
• High-speed 10G Ethernet links in data cabinets and racks
• Environments requiring reduced electromagnetic interference

Key specifications

• Brand: MicroConnect
• Model: MC-SFTP6A0025S
• Type: Cat6a S/FTP RJ-45 patch cable
• Length: 0.25 m
• Data rate: up to 10 000 Mbit/s
• Bandwidth: up to 500 MHz
• Connector: RJ-45 – gold-plated contacts
• Colour: Black
• Weight: 0.02 kg
• MPN: MC-SFTP6A0025S
• EAN: 5704174257691

How to use

Connect one RJ-45 plug to the network port of the source device and the other plug to the destination device or patch panel. Ensure connectors are fully inserted until the latch clicks. Use the meter marking on the boot to confirm the cable length if arranging multiple short runs. Route the cable without excessive bending and avoid tight loops to preserve signal integrity.

Recommendations

For optimal 10G performance, keep the cable length short as intended (0.25 m) and avoid running it parallel and close to large power cables or sources of strong EMI. Inspect connector latches before installation to ensure the protective feature is intact.