Microconnect MC-UTP6A005W Cable de red blanco 0,5 m Cat6a U/UTP (UTP)

The MicroConnect CAT6a Patch Cable MC-UTP6A005W is a 0.5 m networking cable designed for high-speed connections up to 10000 Mbit/s and frequencies up to 500 MHz. It uses U/UTP construction and gold-plated contacts to reduce interference and improve signal reliability. The cable is finished in white and has RJ-45 connectors on both ends.

Advantages

This Cat6a cable supports 10Gbit Ethernet and provides stable transmission at higher frequencies thanks to its U/UTP design. Gold-plated RJ45 contacts improve conductivity and connection durability. The connectors include 50µ" gold plating and a reinforced latch protector to reduce the risk of clip breakage. Meter markings on the boot allow easy identification of cable length during installation.

Suitable for

• 10Gbit Ethernet links in data centers and server rooms
• High-bandwidth desktop and workstation connections
• Patch panels, switches and routers in office networks
• Short-distance point-to-point links where a 0.5 m cable is required

Key specifications

• Standard: Cat6a
• Length: 0.5 m
• Connectors: RJ-45 to RJ-45
• Maximum data rate: 10000 Mbit/s
• Frequency: up to 500 MHz
• Shielding: U/UTP
• Contacts: gold-plated
• Colour: White
• Weight: 0.02 kg

How to use

Plug each RJ-45 connector into the corresponding network ports on your devices (switch, router, network card or patch panel). Ensure connectors are fully inserted until the latch clicks to secure the connection. Use the meter marking on the boot to verify cable length when planning routing and installation.

Recommendations

For optimal performance keep cable runs within recommended lengths for Cat6a patching, avoid tight bends and strong mechanical stress on the connectors, and route the cable away from high-power electrical lines to minimize interference.