Microconnect SSTP60015 cable de red gris 0,15 m Cat6 S/FTP (S-STP)

The Microconnect SSTP60015 RJ-45 Cat6 0.15 m Grey is a short S/FTP-shielded Cat6 patch cable designed for reliable connections between network devices such as switches, modems and routers or to structured cabling via patch panels, keystone jacks or wall outlets. With a length of 0.15 m and RJ-45 connectors on both ends, the cable supports data rates up to 10000 Mbit/s and meets the Cat6 specification tested to 250 MHz. The grey cable features latch protection to prevent connector damage in tight installations.

Advantages

This shielded Cat6 cable (S/FTP) reduces electromagnetic interference and crosstalk, improving signal integrity and lowering transmission errors compared with unshielded variants. Backwards compatibility with Cat5e and Cat5 networks ensures easy integration into existing infrastructure. The short 0.15 m length is convenient for connecting closely spaced devices, and the built-in latch protection helps avoid connector breakage during installation.

Suitable for

• Connecting switch to patch panel or router to modem in racks or cabinets
• Short-distance device-to-device links in office and home networks
• High-speed data connections where reduced EMI is required

Key specifications

• Standard: Cat6, tested to 250 MHz
• Shielding: S/FTP (overall shield with individually shielded pairs)
• Connectors: RJ-45 — both ends
• Maximum data rate: up to 10000 Mbit/s
• Length: 0.15 m
• Colour: Grey
• Weight: 0.01 kg

How to use

Plug each RJ-45 connector into the corresponding network port on your devices or into the appropriate ports on a patch panel or wall outlet. Ensure the latch clicks into place to secure the connection; the latch protection reduces the risk of connector damage when inserting through tight spaces. Use the cable for short, direct links where 0.15 m length provides a tidy connection without excess slack.

Recommendations

For optimal performance, avoid sharp bends and tight kinks in the cable, route it away from strong sources of electromagnetic noise where possible, and verify connectors are fully seated. Use shielded cabling and properly grounded equipment when installing in environments with significant EMI.