Microconnect UTP6100 Cable de red gris 100 m Cat6 U/UTP (UTP)

The Microconnect UTP6100 is a 100 m Cat6 UTP networking cable with RJ-45 connectors on both ends, designed for reliable wired connections between network devices such as switches, modems, routers and structured cabling via patch panels, keystone jacks or wall outlets. The cable supports data rates up to 10000 Mbit/s and meets Cat6 performance up to 250 MHz. Its grey jacket and 100 m spool make it suitable for office and home installations where a long-run, high-speed cable is required.

Advantages

This Cat6 cable provides tested performance up to 250 MHz and is backwards compatible with Cat5e and Cat5 installations. The U/UTP construction offers standard unshielded twisted pair performance for typical LAN environments, while RJ-45 connectors on both ends ensure straightforward, industry-standard termination. The product includes latch protection on the connector to reduce the risk of damage during tight installations and comes in a 100 m length for extended runs without joints.

Suitable for

• Wired connections between switches, routers and modems
• Patch panel and keystone jack terminations in structured cabling
• Small office and home networks
• Home entertainment systems and media streaming setups

Key specifications

• Brand: MicroConnect
• Model / MPN: UTP6100
• Length: 100 m
• Category: Cat6 (tested up to 250 MHz)
• Connectors: RJ-45 to RJ-45
• Shielding: U/UTP (unshielded twisted pair)
• Data rate: up to 10000 Mbit/s
• Colour: Grey
• EAN: 5706998247735
• Weight: 1.9 kg

How to use

Unroll the cable to the required length and route it through cable management channels, conduits or ceiling/wall cavities as needed. Terminate each end into RJ-45 ports on devices or into patch panels/keystone jacks following standard wiring schemes (T568A or T568B). Ensure connectors are fully seated and the latch protector is intact to prevent snags during installation. Avoid sharp bends and excessive pulling force; maintain recommended bend radius and secure the cable to prevent strain on terminations.

Recommendations

For optimal performance, keep Cat6 runs separated from strong electrical sources, avoid tight bends at termination points, and use proper patch panels or keystone jacks for structured installations. When mixing with older cabling, note that overall link performance will be limited to the lowest category present in the link.