Módulo transceptor de cobre BlueOptics ET5402-RJ45-BO 10000 Mbit/s RJ-45

The BlueOptics ET5402-RJ45-BO is a copper SFP+ transceiver module designed for 10 Gbit/s Ethernet links over standard RJ-45 cabling. The module supports a maximum data transfer rate of 10000 Mbit/s and complies with CE, RoHS and FCC standards. Compact and lightweight at approximately 20 g, it is intended for use in network switches, routers, storage systems and other common hardware platforms that accept SFP+ RJ-45 modules and follow MSA compatibility guidelines.

Advantages

The ET5402-RJ45-BO provides a familiar RJ-45 interface for simple integration into existing copper cabling infrastructures while delivering 10G performance. Designed and tested to meet MSA interoperability requirements, the module uses quality components to support long service life and stable operation. Integrated digital diagnostics (DDM/DOM) enable real-time monitoring of parameters such as supply voltage, transmitter and receiver optical power and temperature when supported by the host hardware.

Suitable for

Key specifications

How to use

Insert the ET5402-RJ45-BO into an available SFP+ RJ-45 slot on the host device until it latches. Connect the RJ-45 connector to the copper Ethernet cable terminated to the appropriate category (Cat6/Cat6a recommended for reliable 10G performance). Ensure the host device firmware supports third-party SFP+ copper modules and, if DDM/DOM is required, that the host exposes diagnostic registers. After insertion and cable connection, verify link status and speed on the host management interface and perform any required configuration for the 10G link.

Recommendations

For stable 10G operation, use certified Cat6a (or better) cables and keep cable runs within the specified copper distance limits. Verify host compatibility and firmware support for third-party SFP+ RJ-45 modules and enable digital diagnostics only when the host supports reading DDM/DOM parameters.