Módulo transceptor de cobre BlueOptics MTS-SFP-10G-TX/RJ45-BO 10Gbit/s RJ-45

The BlueOptics MTS-SFP-10G-TX/RJ45-BO is a copper SFP+ transceiver module designed for 10Gbit/s network connections with an RJ-45 interface. It complies with CE, FCC and RoHS standards and is intended for high-speed data transmission in networking equipment that accepts SFP+ copper modules. The module is compact and lightweight, making it suitable for integration into switches, routers and other networking devices where a 10 Gigabit Ethernet RJ-45 port is required.

Advantages

This SFP+ transceiver offers a 10Gbit/s data rate over an RJ-45 copper interface and is built to MSA-compatible physical dimensions for broad hardware compatibility. It is CE, FCC and RoHS compliant and weighs approximately 20 g, which simplifies handling and installation. The design focuses on stable high-speed transmission and compatibility with common SFP+ host devices that support copper RJ-45 SFP+ modules.

Suitable for

Key specifications

How to use

Install the BlueOptics MTS-SFP-10G-TX/RJ45-BO into an available SFP+ slot on compatible network equipment, ensuring the host device supports copper RJ-45 SFP+ modules. After seating the module, connect a standard Cat6a/Cat7 Ethernet cable to the RJ-45 port to establish a 10G link. Configure the host device as required for 10GBASE-T operation and verify link status via the device management interface or link LEDs. Power down the system only if recommended by the equipment vendor when inserting or removing modules to avoid transceiver or port damage.

Recommendations

Use appropriate shielded Ethernet cabling rated for 10 Gbit/s (Cat6a or Cat7) and follow manufacturer guidelines for cable length and environmental conditions to ensure stable 10GBASE-T connections. Verify host compatibility with copper SFP+ modules and enable any required firmware or driver support for Digital Diagnostics if monitoring is needed.