Módulo transceptor de fibra óptica BlueOptics 10121 10000 Mbit/s XFP 850 nm

The BlueOptics 10121 fiber optic transceiver module provides a 10 Gbit/s data link using an XFP interface and an 850 nm wavelength. Designed for insertion into compatible XFP ports, this module supports high-speed short-range connections over multimode fiber and is intended for use in networking equipment where a standardized 10 Gigabit optical interface is required. The compact XFP form factor allows easy replacement or upgrade of optical ports in switches, routers and media converters that accept XFP modules.

Advantages

The module delivers a stable 10000 Mbit/s throughput with low latency and is compatible with standard XFP host interfaces, enabling interoperability with a wide range of network devices. Operation at 850 nm is optimized for multimode fiber links, offering reliable short-range performance. The small XFP package enables hot-pluggable installation and straightforward maintenance without extensive system downtime.

Suitable for

• Short-range 10 Gigabit Ethernet links over multimode fiber
• Upgrading or replacing XFP optical ports in switches and routers
• Data center server interconnects and aggregation switches
• Fiber connectivity in enterprise LAN backbones

Key specifications

• Interface type: XFP
• Nominal wavelength: 850 nm
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Form factor: XFP optical transceiver module
• Optimized for multimode fiber short-range links

How to use

Ensure the host device supports XFP modules and that firmware or hardware compatibility is met. Power down or follow the host's hot-swap procedure, insert the BlueOptics 10121 into an empty XFP slot until it seats securely, and observe the host port indicators for link status. Connect the multimode fiber patch cable with compatible connectors and verify link negotiation at 10 Gbit/s through network management or diagnostic LEDs. If required, configure the host interface settings for speed and duplex according to network policies.

Recommendations

Use this 850 nm XFP transceiver with multimode fiber (OM2/OM3/OM4) for reliable short-range 10 Gigabit links. Keep fiber connectors clean and avoid bending the fiber beyond recommended radii. Verify that the host equipment explicitly supports XFP modules and check optical reach and cable type to match your application.