Módulo transceptor de fibra óptica BlueOptics 409-10007-BO XFP LC aluminio 20 g

The BlueOptics 409-10007-BO XFP LC Aluminium 20g is a fiber optic transceiver module designed for high-speed single-mode optical links. It uses an XFP interface with an LC duplex connector and is housed in an aluminium body weighing approximately 20 g. The module supports 10G-class optical transmission over single-mode fiber and is built to comply with MSA-compatible XFP form-factor requirements for use in compatible network equipment.

Advantages

This transceiver provides a compact XFP form factor with an LC duplex connector, enabling simultaneous transmit and receive over separate fibers. Its lightweight aluminium enclosure contributes to mechanical durability and thermal dissipation. The module is designed to meet common interoperability expectations for XFP-based 10G links and is suitable for applications requiring single-mode optical transmission at long reach.

Suitable for

• 10 Gigabit Ethernet and similar 10G optical links
• Single-mode fiber connections requiring LC duplex terminations
• Integration into switches, routers and storage systems that accept XFP modules

Key specifications

• Interface type: XFP
• Connector type: LC duplex
• Optical medium: single-mode fiber
• Housing material: aluminium
• Typical weight: 0.02 kg (approx. 20 g)

How to use

Install the transceiver into any compatible XFP slot on network equipment following the vendor’s hot-swap and insertion guidelines. Connect LC duplex single-mode patch cords to the transmitter and receiver ports, ensuring correct fiber polarity. Verify link status in the host device and, if applicable, enable or check Digital Diagnostics Monitoring (DDM/DOM) functionality through the equipment management interface to monitor supply voltage, optical output/input levels and temperature if supported by the host.

Recommendations

Use single-mode LC duplex patch cords and maintain clean connector endfaces to ensure optimal signal quality. Confirm that the target device officially supports XFP modules of this type and that any required DDM/DOM support is enabled in the host for remote diagnostics. Follow the equipment manufacturer’s handling and ESD precautions when inserting or removing the module.