Módulo transceptor de fibra óptica BlueOptics 740-069170-BO 10000 Mbit/s SFP+

The BlueOptics 740-069170-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s network links. It supports single-mode fiber transmission with LC duplex connectivity and a nominal 10 000 Mbit/s data rate. The module is finished in silver, weighs approximately 20 g and meets CE, RoHS and FCC conformity requirements, making it suitable for integration into equipment that accepts SFP+ MSA-compatible transceivers.

Advantages

This SFP+ transceiver provides a compact, hot-pluggable solution for high-speed optical connections and follows common MSA form-factor practices to ensure broad compatibility with networking hardware. The module’s single-mode optical design and LC duplex interface enable simultaneous transmit and receive channels over separate fibers, supporting long-reach optical links. Compliance with CE, RoHS and FCC standards ensures adherence to common safety and environmental requirements.

Suitable for

• 10 Gbit/s Ethernet links over single-mode fiber
• Inter-switch uplinks and data center aggregation
• Router and switch ports that accept SFP+ transceivers
• Storage and high-bandwidth server connections

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Optical fiber type: single-mode fiber (LC duplex connector)
• Typical range: designed for long-reach single-mode links (up to several kilometers, depending on network design and fiber)
• Color: silver
• Weight: 0.02 kg
• Standards and conformity: CE, RoHS, FCC

How to use

Install the BlueOptics SFP+ by inserting it into an appropriate SFP+ slot on a switch, router or other network device while the device is powered according to the vendor’s hot-plug guidance. Connect LC duplex single-mode fiber patch cords to the module’s transmit and receive ports, observing correct polarity between connected transceivers. After insertion and physical cabling, verify link status and network configuration on the host device. For environments that support digital diagnostics (DDM/DOM), enable or check monitoring functions in the host to view real-time optical parameters if available.

Recommendations

Use high-quality single-mode LC duplex patch cords and, where applicable, compatible patch panels to achieve optimal signal quality and range. Confirm that the target hardware officially supports third-party SFP+ modules or provides a compatible SFP+ interface. If digital diagnostic monitoring is required, ensure the host device supports DDM/DOM to monitor optical power, bias current and temperature. Follow ESD precautions during handling and perform compatibility checks before large-scale deployment.