Módulo transceptor de fibra óptica BlueOptics 740-080724-BO 100000 Mbit/s LC

The BlueOptics 740-080724-BO is a QSFP28 fiber optic transceiver module designed for high-speed data transfer up to 100000 Mbit/s. It features an LC duplex interface, a metal housing in silver colour and a compact, lightweight design of approximately 0.04 kg. The module supports single-mode fiber transmission and is intended for use in networking equipment and data centre environments that require stable 100G connections.

Advantages

This BlueOptics transceiver conforms to MSA-compatible QSFP28 form factors and provides a standardized LC interface for duplex fiber connections. The metal housing ensures mechanical durability and helps with heat dissipation in rack-mounted systems. With support for 100000 Mbit/s throughput and a small, lightweight design, the module is suitable for dense installations and replacement or expansion of existing 100G links. Tested compatibility and consistent component selection aim to deliver reliable operation over long service lives.

Suitable for

• High-speed data centre uplinks and aggregation
• 100G Ethernet and Fibre Channel over Ethernet interconnects
• Switches, routers and storage systems that accept QSFP28 with LC duplex connections
• Single-mode fiber links requiring CWDM-capable optical transceivers

Key specifications

• Form factor: QSFP28
• Maximum data transfer rate: 100000 Mbit/s
• Interface: LC duplex
• Optical medium: single-mode fiber (CWDM-capable transmit/receive)
• Housing material and colour: metal, silver
• Weight: approximately 0.04 kg

How to use

Install the BlueOptics QSFP28 module into a compatible QSFP28 slot on your switch, router or other networking hardware while the host device is powered down or following the manufacturer's hot‑swap instructions. Connect LC duplex single-mode fiber patch cords to the module's LC interface, observing transmit/receive orientation. Ensure the host platform supports the transceiver type and any digital diagnostics features you intend to use. After installation, verify the link status and configure the corresponding port settings on your network device to match the intended protocol and speed.

Recommendations

For optimal performance, use quality single-mode LC patch cords and maintain clean connector endfaces. Verify that the host hardware supports QSFP28 modules with CWDM operation and any digital diagnostics functions before deployment. Perform link tests after installation and periodically check optical power and device temperature where monitoring is available.