Módulo transceptor de fibra óptica BlueOptics 81.86T-P010GSRM-R6-BO SFP+ 300m

The BlueOptics 81.86T-P010GSRM-R6-BO SFP+ 300m is a fiber optic transceiver module intended for 10G optical links over multi-mode fiber. Housed in aluminium and weighing approximately 20 grams, this SFP+ module provides 10GBASE-SR optical transmission with LC duplex connector compatibility and an operating range up to 300 metres on appropriate multi-mode fiber. The module follows MSA SFP+ form-factor conventions and supports transmission and reception at 850 nm suitable for Ethernet and related high-speed protocols.

Advantages

The module offers compact mechanical design and a lightweight aluminium housing for durability and thermal conduction. It implements standard SFP+ electrical and optical interfaces for straightforward interoperability with equipment that supports 10GBASE-SR SFP+ transceivers. Built-in support for digital diagnostics (DDM/DOM) enables real-time monitoring of key operating parameters such as supply voltage, laser bias current, transmit output power, receive input power and temperature when the host hardware supports these features.

Suitable for

• 10 Gigabit Ethernet links over multi-mode fiber within data centres and enterprise networks
• Short-reach fiber connections between switches, routers and storage systems up to 300 m
• High-speed interconnects in network equipment that accept SFP+ 10GBASE-SR modules

Key specifications

• Form factor: SFP+ (10 Gbps)
• Transmission wavelength: 850 nm (Tx/Rx)
• Maximum typical reach: up to 300 metres on multi-mode fiber
• Connector type: LC duplex
• Housing material and colour: aluminium
• Weight: approx. 0.02 kg
• Digital diagnostics: DDM/DOM support (if supported by host)

How to use

Install the transceiver into any compatible SFP+ slot on network equipment that supports 10GBASE-SR modules. Ensure the host device firmware or driver supports third-party SFP+ modules and DDM/DOM if monitoring is required. Connect LC duplex multi-mode fiber patch cords to the module, observing correct transmit/receive orientation. After physical connection, verify link status and negotiated speed on the host device and check diagnostic values via the management interface if available.

Recommendations

Use OM3/OM4 multi-mode fiber to achieve reliable links near the maximum distance; avoid bending or stressing fiber connectors and keep transceiver optical interfaces covered until installation. Verify compatibility with the specific switch or router model and consult the host vendor documentation for any required configuration or firmware settings to enable third-party transceivers and DDM functions.