Módulo transceptor de fibra óptica BlueOptics 90-QS00SF1101-BO SFP 550 m

The BlueOptics 90-QS00SF1101-BO is a single-port SFP fiber optic transceiver module designed for short-range multimode fiber links. It supports 1000Base-SX class transmission with an 850 nm transmitter and receiver, LC duplex connector and a specified reach of up to 550 m. Housed in an aluminium enclosure and weighing approximately 20 g, the module is built to meet MSA form-factor requirements for use in compatible switches, routers and storage devices that accept SFP 1000Base-SX optics.

Advantages

The module provides gigabit-capable optical connectivity over multimode fiber with an LC duplex interface and compact SFP footprint suitable for hot-pluggable installation. Aluminium housing offers mechanical robustness while the lightweight design simplifies handling and installation. Compliance with MSA interface standards ensures compatibility with hardware platforms that support 1000Base-SX SFP optics. Integrated transmitter and receiver operating at 850 nm are intended to deliver stable optical link performance for up to 550 meters.

Suitable for

• Short-range multimode fiber uplinks between switches and routers (up to 550 m)
• Server-to-switch or switch-to-switch connections in data centres and wiring closets
• Storage area network links and Fibre Channel over Ethernet applications up to 1.25 Gbps
• Replacement or expansion of SFP ports in networking equipment that supports 1000Base-SX

Key specifications

• Form factor: SFP (hot-pluggable)
• Data rate: up to 1.25 Gbps (1000Base-SX)
• Wavelength: 850 nm (transmit and receive)
• Fiber type: multimode fiber
• Connector: LC duplex
• Maximum reach: up to 550 meters
• Housing material: aluminium
• Weight: ~0.02 kg

How to use

Install the transceiver into an SFP port of a compatible network device while the device is powered according to the equipment manufacturer’s instructions. Connect LC duplex multimode fiber patch cords to the transmit and receive ports, ensuring correct polarity and clean connector end-faces. Verify that the host device supports 1000Base-SX SFP modules and, if applicable, enable or confirm Digital Diagnostic Monitoring (DDM/DOM) support in the system BIOS or management interface to monitor optical parameters. After physical installation, check link LEDs and device status to confirm an active optical link and proper negotiation at gigabit speed.

Recommendations

For reliable performance, use high-quality multimode fiber patch cords and keep LC connectors clean; confirm hardware compatibility with 1000Base-SX SFP modules and enable DDM/DOM monitoring if your platform supports it to track optical power, temperature and other diagnostic parameters.