Módulo transceptor de fibra óptica BlueOptics BTI-10GLR-DD-XFP-BO 10000 Mbit/s XFP

The BlueOptics BTI-10GLR-DD-XFP-BO is a fiber optic transceiver module designed for 10 Gbit/s class optical links. It uses an XFP form factor and LC duplex connector to transmit and receive optical signals over single-mode fiber. The module supports a maximum data transfer rate of 10000 Mbit/s, is compact and lightweight (approximately 20 g), and is finished in silver. It follows MSA-compliant XFP interface standards and is intended for integration into networking equipment that accepts XFP transceivers.

Advantages

This transceiver provides 10GBASE-LR performance for long-reach single-mode links and is built to match industry MSA specifications. It supports simultaneous transmit and receive operation via LC duplex ports and is compatible with common network protocols used at 10 Gbit/s. The compact XFP package and low weight make it suitable for dense equipment configurations. Designed and tested for compatibility and stable operation, the module includes features that facilitate reliable optical connectivity.

Suitable for

Key specifications

How to use

Install the module into a compatible XFP slot on supported network equipment following the vendor's hot‑swap and insertion guidelines. Connect an LC duplex single‑mode patch cable, ensuring correct orientation of transmit and receive fibers. Verify that the host device recognizes the XFP module and confirm link status via the device management interface. If digital diagnostics monitoring (DDM/DOM) is supported by the host, use it to observe supply voltage, laser bias current, optical output/input power and temperature for ongoing link health checks.

Recommendations

Use high-quality single-mode LC duplex patch cords and maintain proper fiber cleaning procedures to ensure optimal optical performance. Confirm that the target hardware supports XFP transceivers and the LR optical class. For critical links, enable and monitor DDM/DOM if available and plan link budget and fiber route to match LR-class reach requirements.