Módulo transceptor de fibra óptica BlueOptics LCP-100MMF-BO 155 Mbit/s SFP

The BlueOptics LCP-100MMF-BO 155 Mbit/s SFP is a compact fiber optic transceiver module designed for multimode fiber links using an LC duplex connector. Supporting data rates up to 155 Mbit/s, this SFP form-factor module is silver in color and weighs approximately 20 g. It complies with CE, RoHS and FCC standards and is intended for use in network equipment that accepts SFP optical modules for short-range optical transmission.

Advantages

The module provides a standards-based SFP interface compatible with MSA-compliant ports, enabling straightforward hot-pluggable installation in switches, routers and other networking devices. Its lightweight metal housing and standardized LC duplex connector simplify handling and integration. Compliance with industry safety and environmental standards helps ensure regulatory suitability for most installation environments.

Suitable for

Key specifications

How to use

Ensure the host device supports SFP optical transceivers and the required 100BASE-FX/155 Mbit/s protocol. Power down or follow hot-swap procedures recommended by the equipment manufacturer, then insert the BlueOptics LCP-100MMF-BO into an available SFP slot until it latches. Connect LC duplex patch cords to the module and to the corresponding port or patch panel, observing correct transmit/receive orientation. Configure the host network device as required for the link speed and protocol. Verify link status and perform any device-side diagnostics or monitoring supported by the equipment.

Recommendations

Use quality multimode LC patch cords and, where possible, compatible transceivers on both ends of the link to achieve optimal performance. Confirm that the host hardware firmware supports the transceiver and, if applicable, enables digital diagnostic monitoring (DDM/DOM) to monitor supply voltage, laser bias, output/received optical power and temperature. Store and handle the module in a clean, dry environment and avoid touching the optical interfaces to prevent contamination.