Módulo transceptor de fibra óptica BlueOptics MG-1000AS3 V2-BO SFP 40000 m

The BlueOptics MG-1000AS3 V2-BO SFP 40000 m is a single‑mode fiber optic transceiver module designed for long‑reach data links. Built in an aluminium housing and weighing approximately 20 g, this SFP module provides a compact form factor and standardized SFP interface for insertion into compatible network equipment. It supports optical data transmission over single‑mode fiber with LC duplex connectivity and is intended for applications that require reliable link performance at distances up to 40,000 metres.

Advantages

The module follows MSA (Multi‑Source Agreement) SFP form‑factor conventions to ensure wide compatibility with devices that accept standard SFP transceivers. Its aluminium case offers mechanical protection and thermal stability while keeping weight low. The transceiver supports simultaneous transmit and receive through an LC duplex connector and is suitable for Ethernet and similar optical protocols at gigabit class speeds over long single‑mode runs. Manufactured components are selected for stable performance and extended operating life.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP into any compatible SFP port according to the host device manufacturer’s installation instructions. Ensure the host device supports the required optical protocol and SFP form factor. Connect an LC duplex single‑mode patch cable between transceivers or to a patch panel, observing correct transmit/receive orientation. Verify link status on the host device and, if supported, enable digital diagnostic monitoring features to observe operational parameters. Follow electrostatic discharge (ESD) precautions when handling the module and keep protective dust caps on the connector when not in use.

Recommendations

For best link quality use single‑mode fiber and high‑quality LC duplex patch cords, maintain clean connector endfaces, and verify device compatibility before deployment. If digital diagnostic monitoring is required, confirm that the host hardware supports DDM/DOM to access real‑time operational values.