Módulo transceptor de fibra óptica BlueOptics MG-10GAS1-BO SFP+ 10000 m

The BlueOptics MG-10GAS1-BO SFP+ 10000 m is a fiber optic transceiver module compatible with 10GBASE-LR connections and designed for single-mode fiber links up to 10 km. Housed in an aluminum casing and weighing approximately 20 g, this SFP+ module provides a compact, MSA-compliant solution for 10 Gbps Ethernet and similar high-speed optical protocols. It uses an LC duplex connector and supports simultaneous transmit and receive operation with 1310 nm optics.

Advantages

The module follows MSA standards for physical and electrical compatibility with a wide range of networking hardware and is compatible with platforms that support the original MG-10GAS1 10GBASE-LR transceiver. Built with high-quality optical and electronic components, it is intended for long operational life and stable performance. The lightweight aluminum housing offers mechanical protection and helps dissipate heat while keeping the module easy to install and handle.

Suitable for

Key specifications

How to use

Install the SFP+ transceiver into a compatible SFP+ cage on a switch, router or other networking device that supports 10GBASE-LR optics. Connect an LC duplex single-mode fiber patch cable, ensuring correct polarity for transmit and receive channels. Verify link status via the host device and, if supported, enable Digital Diagnostics Monitoring (DDM/DOM) to read real-time parameters such as supply voltage, laser bias current, transmitted and received optical power, and temperature. Follow the host equipment vendor’s instructions for hot-plugging and firmware compatibility checks.

Recommendations

For reliable long-distance links, use quality single-mode fiber cabling and LC duplex patch cords, maintain proper fiber polarity, and ensure the host device supports DDM/DOM if diagnostic monitoring is required. Handle the module with care to avoid contamination of fiber interfaces and comply with electrostatic discharge (ESD) precautions during installation.