Módulo transceptor de fibra óptica BlueOptics SFP-10GE-ER-31-CE-BO SFP+ LC aluminio 20 g

The BlueOptics SFP-10GE-ER-31-CE-BO is a fiber optic SFP+ transceiver module designed for 10G data transmission over single-mode fiber. It uses an LC duplex connector and an aluminium housing, and its lightweight construction (approximately 20 g) makes it suitable for dense installations and equipment slots where space and weight matter. The module implements the 10GBASE-ER optical interface with 1310 nm transmit and receive wavelengths and is engineered to meet MSA form-factor and electrical specifications for SFP+ devices.

Advantages

This transceiver supports long-reach optical links up to typical 40 km distances on single-mode fiber, offering immunity to electromagnetic interference and stable high-speed data transport. It is built to MSA standards for mechanical and electrical compatibility, allowing straightforward integration into SFP+ ports on compatible switches, routers and storage interfaces. The aluminium housing and compact SFP+ form factor provide reliable mechanical protection while preserving a low weight for easy handling and installation.

Suitable for

Key specifications

How to use

Install the transceiver by inserting it into a compatible SFP+ port until it clicks into place, following the host equipment manufacturer’s instructions. Connect an LC duplex single-mode fiber patch cable with correct polarity to the module. Ensure both ends of the link use compatible 10GBASE-ER transceivers and verify link status via the host device. If the host supports Digital Diagnostics Monitoring (DDM/DOM), enable or query that function through the system management interface to monitor real-time parameters such as optical power and temperature where supported.

Recommendations

Handle the module with electrostatic discharge precautions and keep dust caps on unused ports. Use quality single-mode fiber patch cords and verify connector cleanliness before mating. Confirm host compatibility with SFP+ 10GBASE-ER optics and, if DDM/DOM is required, ensure the host firmware supports diagnostic monitoring for this transceiver.