Módulo transceptor de fibra óptica BlueOptics TRX100075-BO SFP aluminio 20g

The BlueOptics TRX100075-BO SFP Aluminium 20g is a fiber optic transceiver module designed for 1000BASE-LX single-mode links. Housed in an aluminium casing and weighing approximately 20 g, this SFP module provides optical transmit and receive at 1310 nm via an LC duplex connector. It conforms to MSA SFP form-factor guidelines and is intended for use in network switches, routers and other communication equipment that support standard SFP 1000BASE-LX modules.

Advantages

The module supports up to 1.25 Gbit/s data rates over single-mode fiber and is specified for extended reach usage up to approximately 10 km when used with appropriate fiber and patching. Built to industry MSA standards, it offers interoperable electrical and mechanical characteristics for broad compatibility. The aluminium housing provides basic mechanical protection while the lightweight design simplifies handling and installation.

Suitable for

Key specifications

How to use

Install the BlueOptics TRX100075-BO into a compatible SFP slot on your switch, router or other network device while the device is powered according to the vendor's instructions. Connect LC duplex single-mode patch cables to the module and ensure transmit/receive orientation is correct. Verify link status and negotiate the proper speed on the host device. If the host supports Digital Diagnostic Monitoring (DDM/DOM), enable and monitor supply voltage, laser bias, output power, received power and temperature via the management interface if required.

Recommendations

Use single-mode LC duplex patch cords and maintain clean fiber connectors to preserve signal quality. Confirm that the target hardware supports standard 1000BASE-LX SFP modules and, if you require monitoring, that DDM/DOM is enabled and compatible. For optimal reach and reliability, match the module to appropriate fiber type and calculate link budgets for runs approaching the maximum distance.