Módulo transceptor de red BlueOptics 10G-SFPP-T-BO cobre 10000 Mbit/s SFP+

The BlueOptics 10G-SFPP-T-BO is a copper SFP+ network transceiver module designed for 10 Gbit/s Ethernet links over copper cabling. Its SFP+ form factor provides compatibility with a wide range of switches, routers and network interface cards that accept hot-pluggable SFP+ modules. The module is finished in a silver housing and is specified with a mean time between failures (MTBF) of 1,000,000 hours. It meets CE, FCC and RoHS standards for electromagnetic compatibility and environmental compliance.

Advantages

This SFP+ transceiver supports a maximum data transfer rate of 10,000 Mbit/s in a compact, hot-pluggable SFP+ package, allowing straightforward upgrades of 10G ports without changing existing copper infrastructure. The copper interface reduces optical cabling requirements and is suitable for short-distance connections within racks or across adjacent equipment. Its standardized form factor and compliance with common safety and emissions standards simplify integration and deployment in enterprise and data center environments.

Suitable for

• 10 Gigabit Ethernet connections over copper within racks or between adjacent cabinets
• Upgrading SFP+ ports on switches, servers and routers to 10 Gbit/s
• Short-reach links in data centers, server rooms and telecommunication closets

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Form factor: SFP+ hot-pluggable module
• Housing colour: silver
• Weight: 0.02 kg
• Mean Time Between Failures (MTBF): 1,000,000 hours
• Standards compliance: CE, FCC, RoHS

How to use

Install the BlueOptics 10G-SFPP-T-BO by inserting the SFP+ module into a compatible SFP+ port until it clicks into place; ensure the host device is powered and supports copper SFP+ modules. Connect a suitable high-quality copper cable (consistent with the host’s copper SFP+ interface requirements) between transceiver ports for the link. Configure link settings on connected devices as needed for 10 Gbit/s operation and verify link status through the device management interface or LEDs. To remove the module, disengage any retention mechanism and pull the module straight out while the host is powered down or following hot-swap procedures of the equipment.

Recommendations

For reliable operation, use the BlueOptics 10G-SFPP-T-BO with compatible SFP+ ports and certified copper cables rated for 10 Gbit/s. Follow the equipment manufacturer’s hot-swap and grounding guidelines, keep the module and ports free of dust, and avoid excessive bending or stretching of connected cables. Check firmware or driver compatibility on switches and servers if link negotiation issues occur.