Módulo transceptor de red BlueOptics SFP-48B-BO 1250 Mbit/s 1550 nm

The BlueOptics SFP-48B-BO network transceiver module is an SFP form-factor optical module designed for 1250 Mbit/s data links operating at a 1550 nm transmit wavelength. It provides LC Simplex connectivity and is compatible with ComNet devices that accept standard SFP transceivers. The module is intended for fiber-based network links where stable single-fiber transmit/receive operation, compact SFP packaging and industry-standard interoperability are required.

Advantages

This BlueOptics SFP-48B-BO module follows MSA SFP standards and supports simultaneous send and receive optical transmission via simplex LC. It includes digital diagnostics monitoring (DDM/DOM) functionality when supported by host equipment, enabling real-time reporting of parameters such as supply voltage, laser bias current, transmit/receive optical power and module temperature. The product is manufactured with high-quality optical and electronic components to provide long service life and consistent performance in typical network environments. The compact SFP form factor allows straightforward hot-plug installation into compatible switches, routers and other network devices.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-48B-BO by inserting the module into an available SFP port on ComNet-compatible switches, routers or other networking equipment while the host supports SFP modules. Connect the LC simplex fiber patch cable to the module’s LC connector and route the fiber to the corresponding module or patch panel at the remote end. Ensure the remote transceiver uses the complementary transmit/receive wavelengths (1550 nm transmit / 1310 nm receive for this module) and observe proper fiber handling to avoid damage. If the host device supports DDM/DOM, enable or query the diagnostic registers to monitor operating parameters and link status.

Recommendations

Use single-mode fiber optimized for the module's wavelength pair, verify compatibility with the host device's SFP support list before installation, and avoid bending or stressing fiber connections. For reliable long-term operation, ensure adequate ventilation in equipment racks and verify that the network hardware firmware or drivers accept third-party SFP modules if required by the vendor.