Módulo transceptor de red BlueOptics SP-FE-FX-IDFM-BO 155 Mbit/s SFP 1310 nm

The BlueOptics SP-FE-FX-IDFM-BO is a network transceiver module with an SFP interface designed for optical data transmission at up to 155 Mbit/s. It supports single- and multi-mode fiber cable diameters 9/125 µm, 50/125 µm and 62.5/125 µm and is intended for deployment in equipment that accepts SFP pluggable transceivers. The compact module weighs 20 g and provides a standard LC duplex optical connection for bidirectional signal transfer over fiber.

Advantages

The BlueOptics module follows MSA-compatible SFP form factor and fits into common SFP slots for switches, routers and other network devices. Its support for multiple fiber diameters allows flexible integration into existing fiber infrastructures. The lightweight construction and standardized interface simplify installation, while the specified data rate of 155 Mbit/s meets common Fast Ethernet and legacy optical link requirements.

Suitable for

• 100BASE-FX and other Ethernet or optical links requiring up to 155 Mbit/s
• Interconnecting switches, routers and storage systems with SFP ports
• Upgrading or replacing SFP fiber transceivers in mixed single-/multi-mode networks

Key specifications

• Interface type: SFP (MSA-compatible)
• Maximum data transfer rate: 155 Mbit/s
• Optical wavelength: 1310 nm (transmit and receive)
• Supported fiber diameters: 9/125 µm, 50/125 µm, 62.5/125 µm
• Connector: LC duplex
• Typical use: optical fiber transceiver for network devices
• Weight: 0.02 kg

How to use

Insert the BlueOptics SFP transceiver into an available SFP slot on a compatible network device until it locks into place. Connect LC duplex fiber patch cords to the module's optical ports, observing correct transmit/receive alignment. Ensure the host device supports SFP transceivers and is configured for the intended link speed and protocol. After connection, verify link status through the host device management interface and perform any required link testing or monitoring.

Recommendations

Use appropriate fiber patch cords and clean connector endfaces before mating. Confirm host device compatibility with third-party SFP modules and, when deploying over longer runs or mixed-mode infrastructure, test the link to validate signal quality and performance at 155 Mbit/s.