Módulo transceptor de red de fibra óptica BlueOptics J9152D 10000 Mbit/s SFP+ 1310 nm

The BlueOptics J9152D network transceiver module is a fiber optic SFP+ device engineered for 10 Gbit/s links. Operating at a wavelength of 1310 nm, this compact module supports high-speed point-to-point connections over single-mode or multimode fiber (dependent on fibre type and link budget). It is intended for integration into switches, routers and optical equipment with SFP+ ports to provide stable optical connectivity for data center and enterprise networks.

Advantages

The module delivers a standardized SFP+ form factor for hot-pluggable installation and straightforward replacement. With a rated maximum data transfer rate of 10000 Mbit/s and 1310 nm optical operation, it provides consistent throughput for long-reach and metro links where this wavelength is appropriate. Its compact design reduces space requirements in chassis-based equipment while maintaining compatibility with a wide range of SFP+ ports.

Suitable for

Key specifications

How to use

Install the BlueOptics J9152D into an available SFP+ port on your network device while the device is powered down or, if supported, as a hot-swap operation following the vendor’s safety guidelines. Connect the appropriate fiber cable to the optical port, ensuring correct connector type and polarity. Verify link status and configure interface speed and duplex in your switch or router management interface as needed. Monitor link quality and error counters via device diagnostics to confirm proper operation.

Recommendations

Use compatible single-mode or multimode fiber and appropriate connectors for the intended link distance. Check vendor compatibility lists for SFP+ support on specific switches or routers and follow fiber handling best practices to maintain connector cleanliness and minimize attenuation.