Módulo transceptor de red Ubiquiti UACC-OM-SFP10-1450 11300 Mbit/s SFP+

The Ubiquiti UACC-OM-SFP10-1450 is an SFP+ CWDM optical transceiver module that supports 10G connections over single-mode fiber using a duplex LC UPC connector. It is designed for data transmission up to 20 km and has a maximum data transfer rate of 11,300 Mbit/s. The module is compact and suited for integration into compatible networking equipment that accepts SFP+ form-factor modules.

Advantages

This transceiver provides 10G CWDM connectivity over single-mode fiber with a duplex LC UPC interface, enabling long-reach links up to 20 km. It is compatible with SFP+ ports and supports high data throughput up to 11,300 Mbit/s. The small form factor allows easy installation in standard SFP+ slots without requiring additional cabling adapters.

Suitable for

• 10G uplinks between switches and routers
• Long-distance fiber links in campus and metropolitan networks
• Data center connections requiring CWDM wavelength multiplexing
• Edge and aggregation network segments using single-mode fiber

Key specifications

• Form factor: SFP+
• Technology: CWDM optical transceiver
• Data rate: up to 11,300 Mbit/s
• Wavelength: CWDM (specific wavelength indicated by model: 1450 nm)
• Maximum reach: up to 20 km over single-mode fiber
• Connector: duplex LC UPC
• Colour: grey, white
• Manufacturer part number (MPN): UACC-OM-SFP10-1450
• EAN: 810084694732

How to use

Insert the SFP+ transceiver into an available SFP+ port on a compatible switch, router or transceiver slot, ensuring the module clicks into place. Connect a single‑mode duplex LC UPC fiber cable of appropriate CWDM wavelength (1450 nm) to the module. Verify link status on the host device and configure network settings as required for 10G operation. Follow equipment vendor guidelines for hot‑swap procedures and electrostatic discharge precautions.

Recommendations

Use single‑mode fiber with correct CWDM multiplexing equipment when integrating multiple wavelengths. Confirm compatibility with the host device firmware and SFP+ port specifications before deployment. For reliable 20 km links, use fiber with suitable attenuation characteristics and proper connectors.