Módulo transceptor QSFP BlueOptics QSFP-100G-PSM4-T2-BO 100000 Mbit/s QSFP28

The BlueOptics QSFP-100G-PSM4-T2-BO is a QSFP28 fiber optic transceiver module engineered for 100000 Mbit/s (100G) optical links. Housed in a metal casing and weighing approximately 4 g, this compact module provides a standardized MPO/MTP interface for single-mode fiber and follows MSA guidelines for QSFP28 transceivers. It operates at 3.3 V input and supports simultaneous transmit and receive channels with CWDM to enable high-density 100GBASE-PSM4 links over short single-mode fiber runs up to around 2 km when used with appropriate patching.

Advantages

The transceiver is compatible with major hardware platforms that support the Juniper QSFP-100G-PSM4-T2 form factor and is tested for interoperability and software adaptation. Built from high-quality optical lasers and IC components, the module offers stable optical performance, Digital Diagnostics Monitoring (DDM/DOM) support for remote parameter monitoring, and a design intended for long operational lifetime and high MTBF.

Suitable for

Key specifications

How to use

Install the BlueOptics QSFP-100G-PSM4-T2-BO into a compatible QSFP28 slot on the switch, router or other network device following the host vendor’s insertion and hot-swap guidelines. Connect an appropriate MPO/MTP single-mode fiber patch cable or patch panel to the transceiver, ensuring correct fiber polarity and mating. Verify that the network device recognizes the module and, if required, enable DDM/DOM monitoring in the host management interface to read real-time parameters such as supply voltage, laser bias, output and received power, and temperature.

Recommendations

For reliable performance, use high-quality single-mode MPO/MTP patch cords and ensure link loss budgets are within recommended margins. Confirm host compatibility and software support for Juniper QSFP-100G-PSM4-T2 compatible modules before deployment. Keep fiber connectors clean and follow ESD precautions when handling the transceiver.