Módulo transceptor SFP BlueOptics 01-SSC-9791-BO fibra óptica 1000 Mbit/s

The BlueOptics 01-SSC-9791-BO is an SFP fiber optic transceiver module designed for single‑port network uplinks with a maximum data transfer rate of 1000 Mbit/s. The module features a metal housing, operates from a 3.3 V input, and weighs approximately 20 g. With a specified MTBF of 1,000,000 hours, it is intended for use in systems that accept standard SFP form‑factor modules and for applications requiring a compact, hot‑pluggable solution for gigabit connections.

Advantages

The module’s metal housing provides mechanical robustness and helps with thermal dissipation during continuous operation. Compliance with common SFP interface standards ensures wide interoperability with devices that support SFP transceivers. Low weight and standard power requirements make the transceiver easy to install and replace without system modifications. An MTBF rating of 1,000,000 hours indicates long operational life under normal conditions.

Suitable for

• Gigabit Ethernet uplinks and edge ports
• Network switches, routers and storage systems with SFP slots
• Data center and campus network links requiring hot‑pluggable transceivers

Key specifications

• Form factor: SFP (small form‑factor pluggable)
• Maximum data rate: 1000 Mbit/s
• Operating voltage: 3.3 V
• Housing: metal
• Weight: 20 g
• Designed mean time between failures (MTBF): 1,000,000 hours

How to use

Install the transceiver into a compatible SFP slot on the target device while the host port is powered according to the equipment manufacturer’s guidance. Ensure the receiving device supports the SFP form factor and the intended link speed. Connect the appropriate fiber or copper patch cable, confirm link activity through the host device indicators or management interface, and, if required, perform any device‑side configuration for the interface (for example enabling the port or setting speed/duplex). Use anti‑static precautions when handling the module.

Recommendations

Verify compatibility with the host hardware and firmware before deployment. Use suitable patch cords and, where available, enable digital diagnostic monitoring (DDM/DOM) on host equipment to monitor operational parameters. Store unused modules in anti‑static packaging and protect optical interfaces with dust caps when not connected.