Módulo transceptor SFP+ BlueOptics 0231A0A7-BO 10000 Mbit/s 1310 nm

The BlueOptics 0231A0A7-BO SFP+ transceiver module is designed for high-speed single-mode fiber connections. It supports up to 10000 Mbit/s data transfer rate and operates at a wavelength of 1310 nm. The module features an SFP+ interface and an LC duplex connection suitable for 10GBASE-LR optical links. Weighing approximately 20 g and compliant with RoHS, this compact transceiver is intended for integration in network equipment that supports standard SFP+ 10G optics.

Advantages

The module delivers 10 Gbit/s-class optical connectivity over single-mode fiber with a compact SFP+ form factor compatible with MSA-compliant ports. With a documented mean time between failures (MTBF) of 1,000,000 hours and a lightweight silver housing, it provides reliable service life and easy handling during installation. The device supports standard digital diagnostic monitoring features when the host hardware exposes DDM/DOM, enabling remote monitoring of key optical parameters.

Suitable for

• 10 Gigabit Ethernet links over single-mode fiber
• Long-reach optical connections in switches and routers
• Interconnecting data center equipment and storage systems
• Network upgrades and replacements where SFP+ 10GBASE-LR is required

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s
• Optical wavelength: 1310 nm
• Connector type: LC duplex
• Cable type: single-mode fiber (SMF)
• Compliance: RoHS
• Weight: 0.02 kg
• Product colour: Silver

How to use

Install the BlueOptics SFP+ transceiver into a compatible SFP+ port on your switch, router or network device until it latches. Connect LC duplex single-mode fiber patch cords, ensuring transmit and receive fibers are correctly oriented between link endpoints. Configure the host interface for the appropriate 10G optical link settings if required by the device operating system. If DDM/DOM monitoring is needed, enable and read diagnostics through the host management interface when supported.

Recommendations

Use factory-tested single-mode fiber patch cords and, where possible, a cable management system or patch panel to protect connectors. Verify hardware compatibility and software support for SFP+ 10GBASE-LR optics in the target device before deployment and perform link tests after installation to confirm signal levels and diagnostics.