Módulo transceptor SFP+ BlueOptics 100-01510-BXD-40-BO 10000 Mbit/s

The BlueOptics 100-01510-BXD-40-BO is an SFP+ transceiver module engineered for 10 Gigabit Ethernet fiber optic links. It supports a maximum data transfer rate of 10000 Mbit/s and is intended for use in high-speed network environments where reliable, compact optical connectivity is required. The module uses an LC (UPC) fiber optic connector, has a silver housing and a lightweight design of approximately 20 g, enabling straightforward insertion into compatible SFP+ ports without adding significant weight to equipment racks.

Advantages

This SFP+ transceiver offers a long operational reach of up to 40000 m over suitable single-mode fiber, enabling extended-distance connections between switches, routers and media converters. The module provides a high mean time between failures (MTBF) of 1,000,000 hours, indicating extended reliability for continuous network operation. Its standard SFP+ form factor and 10 Gigabit Ethernet interface ensure broad compatibility with modern networking hardware while the LC (UPC) connector supports stable optical coupling.

Suitable for

• Point-to-point long-reach fiber links in enterprise and carrier networks
• High-bandwidth uplinks between switches and data center equipment
• Integration into media converters and SFP+ compatible routers or switches
• Network upgrades requiring compact, hot-pluggable 10 Gbps optical modules

Key specifications

• Maximum data transfer rate: 10000 Mbit/s
• Maximum transfer distance: 40000 m
• Ethernet interface type: 10 Gigabit Ethernet
• Fiber optic connector type: LC (UPC)
• Product colour: Silver
• Weight: 0.02 kg
• Form factor: SFP+

How to use

Install the BlueOptics SFP+ module by aligning the LC connector with the fiber patch cable and inserting the module into an available SFP+ slot on the switch, router or media converter until it clicks into place. Ensure the connected fiber is of the appropriate type and quality for long-reach links and that transceiver settings on the host device match the desired link speed and duplex. For hot-pluggable operation, confirm the operating equipment supports online insertion and removal; if not, power down the device before installing or removing the module.

Recommendations

Use single-mode fiber and low-loss LC patch cables for distances up to 40000 m, and verify link integrity with appropriate diagnostic tools after installation. Keep connectors clean and protected from dust; follow standard ESD precautions when handling the transceiver. Confirm firmware and compatibility lists for your networking equipment to ensure full interoperability.