Módulo transceptor SFP BlueOptics 10060-BO 155 Mbit/s 1310 nm

The BlueOptics 10060-BO SFP transceiver module is a compact fiber optic module designed for single-mode links. It supports a maximum data transfer rate of 155 Mbit/s at a wavelength of 1310 nm and is supplied in a silver metal housing with a lightweight construction of approximately 20 g. The module uses the SFP form factor and LC duplex physical interface and is suitable for insertion into network equipment that accepts SFP modules following MSA specifications.

Advantages

The module provides a standardized SFP interface for easy hot-pluggable installation and removal. Its 1310 nm transmitter and receiver are intended for single-mode fiber transmission, enabling longer link distances compared with typical multimode transceivers. The small, lightweight metal housing supports dense port installations and helps maintain signal stability in rack-mounted network devices.

Suitable for

• Point-to-point single-mode fiber links
• Switches and routers with SFP slots
• Network equipment upgrades or spare inventory

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 155 Mbit/s
• Operating wavelength: 1310 nm
• Connector type: LC duplex
• Optical medium: single-mode fiber
• Typical weight: 0.02 kg
• Product color: silver

How to use

Power down or follow hot-swap procedures recommended by your network equipment vendor before inserting or removing the BlueOptics 10060-BO module. Align the LC duplex connector with the module port, insert until it seats securely, and connect the single-mode fiber patch cable. Configure the host device according to its interface and link speed settings; the module presents as an SFP port to the system and operates at the supported 155 Mbit/s rate when negotiated with the connected device.

Recommendations

Verify compatibility with your host hardware and firmware before deployment, use appropriate single-mode fiber and LC duplex connectors, and follow electrostatic discharge (ESD) precautions when handling the transceiver. Store unused modules in protective packaging to avoid contamination of optical interfaces.