Módulo transceptor SFP BlueOptics 10GB-LR-SFPP-G-BO 10000 Mbit/s

The BlueOptics 10GB-LR-SFPP-G-BO is an SFP+ fiber optic transceiver module designed for 10 Gigabit Ethernet links. With a specified maximum data transfer rate of 10000 Mbit/s and support for single-mode fiber up to 10000 m, this compact silver module provides a standardized LC connector interface in an SFP+ form factor. The module is intended for integration into compatible switches, routers and media converters where reliable long-reach optical connectivity is required.

Advantages

The transceiver offers a high data rate of 10 Gbit/s in a small SFP+ package, enabling high-density port deployment while conserving rack space. Its LC fiber connector and single-mode reach up to 10 km support long-distance links without additional equipment. With a low weight and industry-standard form factor, the module is straightforward to install and replace in devices that accept SFP+ modules.

Suitable for

• 10 Gigabit Ethernet uplinks between switches and routers
• Long-distance single-mode fiber connections up to 10 km
• Server-to-switch links in data centers and campus networks
• Media converter and transceiver upgrades in networking equipment

Key specifications

• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Maximum transfer distance: 10000 m (single-mode fiber)
• Form factor: SFP+ (SFP compatible physical size)
• Fiber connector type: LC duplex
• Ethernet interface type: 10 Gigabit Ethernet
• Product colour: Silver
• Weight: 0.02 kg
• MTBF: 1000000 hours

How to use

Before installation, ensure the target port supports SFP+ modules and that the device firmware permits third-party transceivers if required. Handle the transceiver by the housing and avoid touching the optical interfaces. Insert the module into the SFP+ slot until it latches, then attach LC fiber cables to the duplex connector. Power on the connected devices and verify link status and negotiated speed through the switch or router management interface. For removal, power down the port if recommended, release the latch and withdraw the module carefully.

Recommendations

Use single-mode LC fiber patch cables rated for 10 Gbit/s and maintain clean connector endfaces to prevent signal loss. Observe electrostatic discharge precautions when handling the transceiver and store unused modules in protective packaging. Verify compatibility with the host device and test the link after installation to confirm full 10 Gbit/s operation.