Módulo transceptor SFP BlueOptics 1G-SFP-BXD-BO 1250 Mbit/s plata

The BlueOptics 1G-SFP-BXD-BO 1250 Mbit/s Silver is a compact fiber optic SFP transceiver module designed for 1.25 Gigabit Ethernet links. It supports a maximum data transfer rate of 1250 Mbit/s and enables single-mode fiber connections with LC connectors. The module's small form factor and silver housing make it suitable for installation in SFP ports of switches, routers and media converters where space and reliable fiber connectivity are required.

Advantages

This SFP transceiver offers a high mean time between failures (MTBF) of 1,000,000 hours, providing long-term operational reliability. Its support for a 20 km maximum transfer distance allows point-to-point links across campuses or between building sites. The LC fiber connector and standard SFP form factor ensure broad compatibility with network equipment that accepts hot-swappable SFP modules.

Suitable for

• Extending Ethernet links over single-mode fiber up to 20 km
• Use in enterprise switches and routers with SFP ports
• Interconnecting building-to-building network segments
• Replacement or upgrade of existing SFP fiber transceivers

Key specifications

• Maximum data transfer rate: 1250 Mbit/s (1.25 Gbit/s)
• Maximum transfer distance: 20,000 m (20 km)
• Ethernet interface type: 1.25 Gigabit Ethernet
• Fiber optic connector: LC
• Form factor: SFP (small form-factor pluggable), hot-swappable
• Product colour: Silver
• Weight: 0.03 kg
• High MTBF: 1,000,000 hours

How to use

Install the BlueOptics 1G-SFP-BXD-BO into an empty SFP slot on a compatible switch, router or media converter while the device is powered down or during hot-swap if the host supports it. Connect a single-mode fiber cable with LC connectors to the module's LC port, observing correct transmit/receive orientation. Configure the network interface on the host device as required for 1.25 Gbit/s operation and verify the link status via the host equipment management interface or status LEDs.

Recommendations

Use single-mode fiber cabling rated for the intended distance and ensure clean LC connector end-faces to maintain signal quality. Verify compatibility with the host device's supported SFP types and firmware. For long-term reliability, avoid excessive bending of the fiber and maintain adequate ventilation around racks and devices to prevent overheating.