Módulo transceptor SFP BlueOptics 1G-SFP-SX-OM-T-BO 1250 Mbit/s plata

The BlueOptics 1G-SFP-SX-OM-T-BO is a single‑mode fiber optic SFP transceiver module designed for 1 Gbit/s Ethernet links. Supporting a maximum data transfer rate of 1250 Mbit/s and housed in a compact SFP form factor with a silver finish, the module is intended for insertion into compatible network switches, routers and media converters. It offers a high mean time between failures (MTBF ~1,000,000 hours) and meets CE, FCC and RoHS conformity requirements, making it suitable for professional network environments that require standard-compliant optical interfaces and low-weight components.

Advantages

The module provides a compact SFP interface that enables hot‑swappable installation and flexible port configuration without system downtime. Its 1250 Mbit/s capability supports Gigabit Ethernet links and short-reach optical connections. The lightweight metal housing in silver ensures mechanical robustness while contributing minimal load to networking equipment. Compliance with CE, FCC and RoHS standards ensures regulatory compatibility for indoor installations in commercial and industrial settings.

Suitable for

• Establishing Gigabit Ethernet links between switches and routers over optical fiber
• Replacing or expanding SFP ports in enterprise and SMB network equipment
• Use in media converters and optical uplink ports for data centers or wiring closets

Key specifications

• Form factor: SFP (Small Form-factor Pluggable)
• Data rate: up to 1250 Mbit/s
• Optical type: fiber optic transceiver (short‑reach application)
• Average reliability: MTBF approximately 1,000,000 hours
• Weight: 0.02 kg
• Housing colour: silver
• Standards: CE, FCC, RoHS compliant

How to use

Power down the host device if recommended by the equipment manufacturer, then insert the SFP module into a compatible SFP port until it seats firmly. Connect the appropriate fiber patch cable to the transceiver's optical connector, observing correct transmit/receive polarity. After connection, verify link status using the host device management interface or LED indicators and configure interface settings (speed/duplex/autonegotiation) as required by your network. To remove the module, disconnect the fiber cable, release any retention mechanism and pull the module straight out of the port.

Recommendations

Use compatible single‑mode or multimode fiber and patch cables as specified by the equipment documentation; avoid excessive bending of fiber, protect the optical connector caps when not connected, and follow electrostatic discharge (ESD) precautions when handling the transceiver.