Módulo transceptor SFP BlueOptics 2682530000-BO 1250 Mbit/s

The BlueOptics 2682530000-BO SFP transceiver module is a compact fiber optic interface designed for small form-factor pluggable ports. Supporting a maximum data transfer rate of 1250 Mbit/s and an LC fibre connector, this silver-coloured SFP module is intended for use in networking equipment that accepts SFP form-factor transceivers. It offers a specified maximum transfer distance of up to 20,000 m and an MTBF of approximately 1,000,000 hours, providing predictable operational characteristics for standard fibre connections.

Advantages

The module’s SFP form factor enables hot-plug installation in compatible switches, routers and media converters without requiring system shutdown. An LC connector ensures compatibility with common duplex multimode and singlemode fibre patch cables, while the supported transfer rate of 1250 Mbit/s matches common 1.25 Gigabit Ethernet optics standards. The silver housing provides a durable external finish and the long rated reach supports both short-haul and extended-distance links depending on the fibre type used.

Suitable for

• Replacing or expanding SFP ports on switches and routers
• Connecting media converters and optical network equipment
• Establishing point-to-point fibre links up to 20 km
• Laboratory, testing and development environments requiring standard SFP optics

Key specifications

• Data transfer rate: 1250 Mbit/s
• Maximum transfer distance: 20,000 m
• Ethernet interface: 1.25 Gigabit Ethernet
• Connector type: LC
• Form factor: SFP (small form-factor pluggable)
• Colour: Silver
• Mean time between failures (MTBF): 1,000,000 hours

How to use

Insert the BlueOptics SFP transceiver into an available SFP slot on compatible networking equipment until it locks in place. Connect the LC-terminated fibre patch cable to the module’s LC connector, observing correct polarity for duplex links. Verify link negotiation and speed on the host device and configure any required interface settings according to the switch or router documentation. To remove the module, disengage the host port and pull the transceiver straight out using the built-in latch or handle.

Recommendations

Use appropriate singlemode or multimode fibre cable and ensure connector cleanliness before mating. Match fibre type, wavelength and cable standards on both ends of the link to achieve the rated distances and reliable operation. Avoid excessive bending or tension on the fibre and operate the transceiver within the equipment manufacturer’s environmental and power specifications.