Módulo transceptor SFP BlueOptics CPAC-TR-1LX-B-BO 1250 Mbit/s LC

The BlueOptics CPAC-TR-1LX-B-BO is a single-port SFP transceiver module intended for fiber-optic network connections. Designed in a compact SFP form factor, this silver module supports a maximum data rate of 1250 Mbit/s and uses an LC duplex interface for single-mode fiber links. It is lightweight (approximately 20 g) and conforms to CE, RoHS and FCC standards for electrical and environmental compliance.

Advantages

This SFP transceiver provides a standardized LC interface in an industry-standard SFP housing, enabling compatibility with devices that accept MSA-compliant modules. The module’s support for up to 1250 Mbit/s makes it suitable for Gigabit Ethernet and other 1.25 G applications over single-mode fiber. Its small size and low weight simplify installation in tight equipment racks and high-density ports, while regulatory compliance supports integration into a wide range of networking environments.

Suitable for

Key specifications

How to use

Insert the module into a compatible SFP slot on the network device while the device is powered down or following the device vendor’s hot-swap instructions. Connect single-mode fiber patch cords with LC duplex connectors to the module’s LC ports, observing correct transmit/receive alignment. Configure the host device’s interface settings as required for the intended protocol (for example, set the port to the appropriate speed and duplex or enable auto-negotiation per device documentation). Verify link status and operational parameters via the host device management interface.

Recommendations

Use single-mode LC patch cords and, where applicable, appropriate SFP port settings recommended by the equipment vendor. Ensure connectors and fiber are clean before mating to maintain optimal signal quality and reduce insertion loss. Confirm that the receiving equipment supports the required protocols and data rates before deployment.