Módulo transceptor SFP+ BlueOptics ER-BO 10000 Mbit/s 1550 nm

The BlueOptics SFP+ ER-BO 10000 Mbit/s 1550 nm is an SFP+ fiber optic transceiver module designed for 10 Gbit/s optical links at a 1550 nm wavelength. It uses an LC duplex connector and follows MSA interface standards for compatibility with a wide range of network equipment. The module supports digital diagnostics (DDM/DOM) for real-time monitoring of parameters such as supply voltage, laser bias current, optical output/input power and temperature, and is manufactured to meet CE, FCC and RoHS requirements. With a rated MTBF of 3,000,000 hours, the transceiver is intended for long-term operation in data center, campus and carrier environments.

Advantages

The transceiver provides 10 Gbit/s optical throughput over single-mode fiber at 1550 nm with LC duplex connectivity, offering electromagnetic immunity and stable long-distance links. Compliance with MSA interface specifications and industry safety and environmental standards ensures interoperability and regulatory conformity. Integrated digital diagnostics enable remote monitoring and troubleshooting of optical links. The unit’s construction relies on quality components, which contributes to extended operational life and reduced maintenance intervals.

Suitable for

Key specifications

How to use

Install the SFP+ ER-BO module into an SFP+ slot on compatible networking hardware such as switches, routers or transceivers that accept MSA-compliant SFP+ modules. Connect LC duplex single-mode fiber patch cables to the module’s LC ports, observing correct transmit/receive orientation. If the host device supports DDM/DOM, enable or query the monitoring interface to read real-time parameters for link diagnostics. Ensure proper ESD precautions during handling and verify compatible firmware or vendor settings if required by the host platform.

Recommendations

For reliable long-distance links, pair the module with single-mode LC duplex patch cords and ensure end-point hardware supports SFP+ 10GBASE-ER operation and DDM/DOM if diagnostics are needed. Maintain clean fiber endfaces and perform optical power and loss measurements during installation to confirm link performance and to avoid damage from excessive optical power.