Módulo transceptor SFP BlueOptics FL-SFP-LH-BO fibra óptica LC aluminio 20 g

The BlueOptics FL-SFP-LH-BO is an SFP fiber optic transceiver module designed for single-mode optical links. It features an LC duplex connector and an aluminium housing, and is specified as a lightweight module at approximately 20 g. The module follows MSA SFP form-factor conventions and is intended for use in network equipment that accepts SFP transceivers for up to gigabit-class optical transmission.

Advantages

The aluminium enclosure provides mechanical protection and thermal dissipation while keeping the module lightweight. The LC duplex interface enables simultaneous transmit and receive over separate fibres in a compact connector format. Designed for single-mode fibre links, the module supports long-reach optical connections and is compatible with standard SFP sockets in networking hardware. Its form factor and tested compatibility simplify replacement and upgrade of SFP ports in switches, routers and storage systems.

Suitable for

Key specifications

How to use

Install the module into a compatible SFP slot on your network device until it clicks into place, ensuring the host hardware supports the SFP transceiver type. Connect the LC duplex fibre patch cable to the module, observing correct transmit/receive orientation. Verify link status on the host device and configure the interface as required by your network. For removal, power down the port if recommended by the device vendor, release the module latch and gently pull the transceiver from the socket.

Recommendations

Use quality single-mode LC patch cables and follow the equipment vendor’s guidance about supported transceiver models and firmware. Ensure dust caps are fitted when the transceiver is not in use and avoid bending fibres beyond recommended radii to maintain signal performance.