Módulo transceptor SFP BlueOptics FL-SFP-LX-BO 1250 Mbit/s plateado

The BlueOptics FL-SFP-LX-BO 1250 Mbit/s Silver is a compact SFP fiber optic transceiver designed for single-fibre and duplex LC connections in standard networking equipment. With a maximum data rate of 1250 Mbit/s and support for long-reach links, this module fits the SFP form factor and is compatible with common hardware platforms that accept MSA-compliant SFPs. The transceiver uses LC connectors and delivers reliable optical transmission over long distances while remaining lightweight and easy to install.

Advantages

The module offers a long mean time between failures (MTBF) that contributes to extended operational availability and reduced maintenance requirements. Its compact SFP design and 20 g weight simplify installation and hot-swap replacement in switches, routers and other network devices. Built to MSA standards, the transceiver is engineered for broad compatibility and consistent optical performance on LC duplex fibre links.

Suitable for

Key specifications

How to use

Ensure the host device supports MSA‑compliant SFP transceivers and the intended optical specifications. Power down or follow the hot‑swap procedure recommended by the device manufacturer, insert the FL-SFP-LX-BO into an SFP port until it latches, and connect LC duplex patch cables to the module and the corresponding remote transceiver or patch panel. Verify link status LEDs and, if available, check the device interface for operational parameters. If the host device supports Digital Diagnostics Monitoring (DDM/DOM), enable and review status readings such as optical power and temperature for ongoing verification.

Recommendations

Use single‑mode LC duplex fibre and matched BlueOptics patch cables for optimal reach and signal quality, and confirm DDM/DOM support in the host equipment to access real‑time diagnostic data. Follow manufacturer guidelines for electrostatic discharge (ESD) protection and clean connectors before mating to maintain reliable optical performance.